Plumbing 101: How to Solve Five Common Plumbing Problems and Avoid Costly Repairs
Plumbing problems can be a significant inconvenience and cause severe damage to your home if not addressed quickly. As a homeowner, it’s essential to know how to identify common plumbing problems and how to fix them. Plumber in Melbourne offer reliable and efficient plumbing services to homeowners and businesses in the city. Trust them for all your plumbing needs.The average hourly wage for a plumber in Australia is AU$ 28.44, which translates to an annual salary of AU$ 64,502. This amount is AU$ 5,386, or 8% lower than the national average salary in Australia. A qualified plumber can expect to start with an average hourly pay of AU$ 21.38. However, the highest pay rate for a plumber can exceed AU$ 43.87 per hour.
In this blog post, covered are the five common plumbing problems and provide the information you need to solve them.
Clogged Drains
One of the most common plumbing problems is a clogged drain. A hair buildup, soap scum, food particles, or other debris can cause this. If left untreated, clogged drains can cause water to back up and overflow, leading to potential water damage in your home. You can use a plunger to dislodge the blockage to fix a clogged drain. If this doesn’t work, you can use a drain snake to remove the blockage. If you’re uncomfortable doing this, you can always call a professional plumber to help.
Leaky Faucets
Leaky faucets can be a nuisance and can also waste a lot of water over time. A worn-out washer or O-ring typically causes a leaky faucet. To fix a leaky faucet, disconnect the water supply to the faucet and then disassemble the faucet to access the washer or O-ring. Replace the worn-out part with a new one, then reassemble the faucet.
Running Toilets
A running toilet can be a significant source of water waste in your home. It’s typically caused by a faulty flapper valve, which allows water to flow continuously from the tank to the bowl. This can cause your water bill to skyrocket if left unchecked. To fix a running toilet, turn off the water supply and remove the tank lid. Check the flapper valve to see if it’s worn out or misaligned. You’ll need to replace it with a new one if it is.
Low Water Pressure
Some factors, including clogged pipes, mineral buildup, or a faulty pressure regulator, can cause low water pressure. Low water pressure can indicate a more serious plumbing problem, so it’s essential to address it promptly.
Check your faucets and showerheads to fix low water pressure to see if the problem is isolated to one area. If it is, you can clean the aerator or showerhead to improve water flow. If the problem is more widespread, you may need to call a plumber to diagnose and fix the issue.
Burst Pipes
Burst pipes can cause harsh damage to your home and can be caused by freezing temperatures or excessive water pressure. If you suspect you have a burst pipe, it’s essential to turn off your water supply immediately to prevent further damage.
To fix a burst pipe, you’ll need to locate the damaged section and cut out the damaged area. Replace the damaged section with a new piece of pipe and then use a pipe clamp to secure the new section in place. Call a professional plumber to help if you’re uncomfortable doing this yourself.
Conclusion
Knowing how to identify and fix common plumbing problems is essential for a homeowner. Clogged drains, leaky faucets, running toilets, low water pressure, and burst pipes are all common plumbing issues that can be easily fixed with the right tools and knowledge. If you’re uncomfortable fixing these problems, don’t hesitate to call a professional Plumber in Melbourne to help. By addressing these issues promptly, you can prevent severe damage to your home and save money on your water bill in the long run.
